CONTENTS OF THE SET : Ultra Clear Coat PART A (High Solid Clear) 30ml x2 Ultra Clear Coat PART B (Hardener) 35ml x1 2K Thinners 30ml x1 SAFETY PRECAUTIONS This product contains Isocyanates. Vapours and Spray Mists are harmful if inhaled. May cause irritations to the skin, eyes, nose and throat. May cause headaches, nausea, and dizziness. Refer to SDS for further information. ENSURE ADEQUATE PERSONAL PROTECTIVE EQUIPMENT (PPE) RATED FOR WORKING WITH ISOCYANATES IS USED AT ALL TIMES AND ADEQUATE VENTIALTION OF WORKSPACE IS ACHIEVED. HOW TO USE : Mix at a ratio of 2:1 10% Thinners. Example, 10ml PART A 5ml PART B (HARDENER) 1.5ml THINNERS. Mix only what you need to use. Once Part B (Hardener) is added to Part A (High Solid Clear), the chemical reaction begins and will be unusable within 30-40 minutes. PART B (HARDENER) HAS A SHELF LIFE OF 6 MONTHS AFTER OPENING. Ensure the surface you are painting is smooth and dust free. Airbrush a light mist to act as a ‘tack’ layer and leave for approximately 5 minutes. Then apply in an even wet coat. If required, add another wet coat after another 5 minutes. Allow 24 hours to harden and cure. To remove any dust particles etc afterwards, polish out using an appropriate grit sandpaper and reapply the Ultra Clear Coat over the area once again. Drying times at ambient temp 20 – 22C : Dust Free – 30 minutes, Tack Free – 12 hours, Fully hardened – 24 hours. Can be polished and buffed after 24 hours minimum. DOWNLOAD WORKING WITH ISOCYANATES & READ FULLY BEFORE USING THIS PRODUCT : https://www.safeworkaustralia.gov.au/system/files/documents/1702/guide-to-handling-isocyanates.pdf SDS PART A : https://www.scalemodeller.com.au/2KCLEARMSDSPKA.pdf SDS PART B : https://www.scalemodeller.com.au/2KCLEARMSDSPKB.pdf KEEP OUT OF REACH OF CHILDREN - STORE IN A DRY, COOL PLACE
